Cutting

There are three automatic circular cutting centres in our premises.

 

Two hydraulic automatic cutting lines Adige TC720 - particularly suitable for cutting pipes of circular, square and rectangle cross-section.

Extent of material cutting: tubes of a diameter of 10 - 80 mm, profile sizes of 10 x 10 mm - 80 x 70 mm, steel bars of a diameter of 12 - 30 mm.

Cutting length: 50 - 3.000 mm.

 

New hydraulic automatic cutting line Adige Twincut - suitable for cutting pipes of circular, square and rectangle cross-section. It allows to cut two bars together up to the diameter 45 mm and one bar up to the diameter 80 mm. 

Cutting capacity (using the two bars regim): tubes of a diameter of 12 - 45 mm, square cross-section profile sizes of 12 x 12 - 40 x 40 mm, rectangle cross-section profile sizes of 15 x 10 - 40 x 35 mm.

Cutting length: 50 - 3.000 mm.

Split-length measuring system - the device is located at the output of the brush machine. Non-contact measurement with laser micrometer, repeatability 5 microns. After checking the length, any non-tolerant parts are separated into a separate container. Graphic presentation on the machine panel, measured values in tables, values assessment and histogram, calculation of the average statistical values, etc.


In order to view this object you need Flash Player 9+ support!

Get Adobe Flash player

 


 

We also offer the possibility of cutting using a semi-automatic band saw Bomar which is capable of cutting material in bundles even at an angle, and on small manual band saws Pilous.